Vinyl Graphics Application

Posted in Lighted Signs on 01/03/2000 11:23 pm by admin

Described here are a few common methods you can use when applying Computer Cut Vinyl Lettering most substrates

Uses a mark of the standard line of pen on the substrate corresponding to the baseline of the text to apply. Hold the line of light in order not to create an appearance of on the substrate. If the request for a vehicle or with a pencil, colored acrylic paint grade chinagraph similar vehicles of certain types of paint may be chinagraph or ink color so it would be advisable to test an inconspicuous area first.

Delete text or logo of the liberation of paper towels and keep firmly at each end. Align the baseline of the text with the line on the substrate, keeping the text just the surface - must be able to see through the tape application.

Lightly press the edges of the surface to obtain the text or logo in place. Using a special applicator (available from your supplier chloride), press firmly into the center out towards the edges, while the fold line towards the end of letters or logo. Repeat the process of working towards the other end.

Lift one corner of the application tape and peel, keeping the surface as flat as possible, doing this helps prevent the vinyl be torn from the substrate and also prevents the paint that is removed when the application is on a painted surface.

Depending on what you used to create the line can be removed by methamphetamine, alcohol, lighter fluid or spirit - Be sure to verify that no damage to the substrate.

Hinge Method

Fold in half and graphics compression of a small dimple in the bottom of the table. Place a piece of tape on each end of the image and security in the substrate. Adjust the position to the fold mark in the application of the tape measuring point is the center of the substrate.

Working with one end at a time around the graph until the Basic is the distance from the edge of the panel - you can use a tape measure or ruler to verify this point. Do the same at the other end yy redial the first point, because probly moved.

When you are sure that the graph is in the correct position to put a band through graphics together somewhere near the mean, preferably with at least one ridge in a space between letters. This is called the hinge.

Take a piece small tape and applied to the substrate, so that the butts against the bottom of the tape application to the end opposite the hinge. Remove the piece of tape at the end, ensuring the graphics to the substrate and turn 180 degrees Grahpics press and a strong back there.

Remove the release paper and wear to the line folding. Note the application of the tape to the substrate surface while maintaining teaching and align the edge of the tape with the edge of the implementation of the tape. Using a special applicator (available from your supplier of vinyl), press firmly into the center out towards the edges, while the fold line towards the end of letters or logo. Repeat the process towards the other end.

Lifting a corner of the tape application and shell, keeping as flat to the surface as possible, making this helps prevent tore the vinyl substrate and also prevents the paint is removed when the application is on a painted surface. This method has the advantage of not having all the lines to mark the position and therefore useful for applications sensitive surfaces.

When the graphics not depend Central, in the absence of adequate space in which to create the hinged lid can be created at one end of the graph or the top or bottom.

About the Author:

Matt Theobald has worked in the exhibition industry for 21 years, designing, building and producing the graphics for exhibition stands, popup displays and bannerstands. He is co-director of Exhibition Display Solutions Ltd in the Thames Valley. http://www.exdisplay.co.uk

Article Source: ArticlesBase.com - A Beginners Guide to the Application of Computer-Cut Vinyl Lettering

Vinyl Graphics Application - Cast Film on Painted Aluminum